环保世界
环保刀模
Home > 关于我们 > 博客 > May 2018
Reasons and solutions for power source burn out of the laser die cutting machine
By Eric  2018-05-17
laser die board cutting machine, laser die cutter, laser die cutting machine,

There are many reasons for the bad power of the laser die board cutting machine. The following is a detailed analysis of the cause of the power failure of the laser die board cutting machine:

timg (21).jpg


1. The power of the laser die cutter is unstable (it is best to connect a regulated power supply separately).

2. Laser die cutter does not have a ground wire (no chance of the machine power supply of the ground wire is high).

3. The effect of water cooling cycle is not good (not only the laser tube life will be shortened when the water temperature is too high, the laser power supply is also the same), can also cause the power failure of the laser die cutter.

4. The laser tube and laser power supply of the laser die cutting machine do not match.

5. Laser die cutting machine’s laser tube seal is not good (dust if the laser tube above the accumulation of too much will form static electricity, this may also affect the life of the laser power supply).

6. Improper operation of laser die cutting machine (usually affecting the power of the laser die cutting machine to 100%, it is recommended to control the power up to 85 or so)
57.8K
环保世界 环保刀模

东 莞 市 益 松 数 控 科 技 有 限 公 司

地址:广东省东莞市南城区白马黄金路华丰大厦三层

Tel: +86(769)3897 1768     Fax: +86(769)2290 1769


邮箱:sales@yisongcnc.com

网站地图 隐私政策 版权所有 © 东莞市益松数控科技有限公司