An error in the processing size is a failure often encountered when using a laser die making machine. This failure not only affects production efficiency but also increases production costs. The reasons for this failure are as below:

1. The laser die cutting machine’s program was written incorrectly. The machining program needs to be checked and repaired.

2. The signal line of laser die making machine is abnormal. You need to replace the signal cable.

3. The processing parameters of laser die cutting machine are set incorrectly. To reset the correct processing parameters.

4. The computer of laser die making machine is not operating normally. The computer needs to be repaired or replaced at this time.

5. The application software of laser die cutting machine is abnormal. At this time, you need to reinstall the software and the driver software of the motion control card.

6. The computer operating system of laser die making machine is faulty or infected with a virus. Need to reinstall the operating system or perform virus killing.

7. Laser die cutting machine power supply is unstable or caused by interference signals. At this time, you need to install a voltage regulator or eliminate interference signals.